Kenwood KRF-X9060D Instruction Manual

Also see for KRF-X9060D: Service manual Service manual Instruction manual

Contents

26 ENListening to a source componentVOLUME CONTROLVOLUME /INPUT SELECTORInput Selector AV AUX1Use the Input Selector and AV AUX keys to select thesource you want to listen to.Selecting a source using each key.1 “DVD/6CH”2 “CD/DVD”3 “PHONO”4 “TUNER”5 “VIDEO 1”6 “VIDEO 2”7 “VIDEO 3”8 “MD/TAPE”9 “AV AUX”2Start playback from the selected source.3Use the VOLUME CONTROL knob or VOLUME +/-keys toadjust the volume.Preparing for playbackSome preparatory steps are needed before starting playback.INPUT MODEMD/TAPEPOWER ON/OFF(KRF-X9060D)POWERON/STANDBY(VR-6070)ON/STANDBY(KRF-X9060D)A SPEAKERS BTurning on the receiver1 Turn on the power to the related components.2 Turn on the power to this receiver by pressing the POWER ON/STANDBY (for VR-6070) or POWER ON/OFF and ON/STANDBY(for KRF-X9060D) key.Selecting the input modeIf you have selected a component connected to the CD/DVD, VIDEO 2,VIDEO 3 or DVD/6CH jacks, make sure that the input mode setting iscorrect for the type of audio signal to be used. 9Selecting MD/TAPESelect the source name corresponding to the component connected tothe MD/TAPE jacks. The initial factory setting is “TAPE”. To change thesource to “MD”, follow the steps below:Hold down the MD/TAPE key for more than 2 seconds.• The source indication changes to “MD”.• To return to the original indication, repeat the above procedure.Selecting the speaker systemPress the A SPEAKERS B key to select the speaker system to beused.A ON : Sound from the speakers connected to the SPEAKERS Aterminals on the rear panel.B ON : Sound from the speakers connected to the SPEAKERS Bterminals on the rear panel. No sound will be heard from thesubwoofer.A+B ON : Sound from both the speakers connected to the SPEAKERSA and B terminals on the rear panel.A+B OFF : No sound from the speakers. Use this setting when listeningwith headphones for stereo sound in all playback modes.The display segments are different depending on the type ofinput signal.The indicator for the speakersyou want to use should be lit.LSL S SB SRC RSP MUTE OPTICAL 6CH INPUTCOAXIAL ANALOG 96kHzfsCINEMACTIVDSP MA B CLIPAUTO DETECTSWLFE• Selecting “6CH INPUT” by pressing the INPUT MODE key, whereby“DVD/6CH” is the input source will cause SPEAKERS A to be selectedautomatically.Normal playback