Kenwood TH-22A Instruction Manual

Also see for TH-22A: Instruction manual Instruction manual Instruction manual Instruction manual Service manual

From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document LibrarySCAN RESUME METHODSWhen using Scan, it's necessary to decide under whatcondition you want your transceiver to continue scanningafter detecting and stopping for a signal. You canchoose Time-operated Scan or Carrier-operated Scan.The default is Time-operated Scan.• Time-Operated ScanYour transceiver stops scanning after detecting asignal, remains there for approximately 5 seconds, andthen continues to scan even if the signal is stillpresent.• Carrier-Operated Scan36Your transceiver stops scanning after detecting asignal and remains on the same frequency until thesignal drops out. There is a 2 second delay betweensignal drop-out and scan resumption to allow time forany responding stations to begin transmitting.SELECTING THE SCAN RESUME METHODUse the following procedure to switch your transceiverbetween Time-operated Scan and Carrier-operated Scan.1 Press [CALL}+ POWER ON to enter Menu Set-up.2 Turn the ENC/SQL control to select Menu No. 03.• The current Scan Resume status appears.• The default is "TO" (time-operated scan).5[APO• n u":;-:~,-,,-- s3 Press [CALL] to select either "TO" or "CO".4 Press any key other than [CALL], [LAMP], or [MONJ]to exit Menu Set-up.Note: Holding [MONt] down while scanning halts Scanregardless whether Time-operated or Carrier-operated Scanis selected. Resume scanning by releasing {MONI].