Kenwood TH-22A Instruction Manual

Also see for TH-22A: Instruction manual Instruction manual Instruction manual Instruction manual Service manual

From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library2 Press [FJ (1 s), (1 ].t APO []P- -- J----------------------3 Turn the ENC/SQL control to select Page memory A.RP· -- J4 Enter your station code (000 to 999) using thenumeric keys.• This entry stores your station code in Page memoryA.5 Select Page memory 1 to 6 by turning the ENC/SQLcontrol.6 Enter a 3-digit group code or individual station codeyou wish to program using the numeric keys.• To restore the frequency display, press [VFO],[MR], [CALL], [T/CT], or [REV].7 To store additional group or individual codes, repeatSteps 5 and 6.You can immediately use the group code or individualstation code that was stored or selected last.44CALLING1 Tune to the prearranged frequency.2 Press [F], [1] to switch ON Page.• "PAG" appears.• Each time this key combination is pressed, Pagetoggles ON and OFF.3 Press [F] (1 s), [1] to select Code Select.4 Turn the ENC/SQL control to select the Page memorywhere the desired group code or individual stationcode has been stored.• If you have not stored the desired Page code in amemory from 1 to 6, select memory 0 and store thePage code at this time.5 Press and hold [PTT], then call the other station afterthe code transmission completes.• The group code (or individual station code) andyour station code are transmitted.Note:~ When Page is ON, Scan cannot be used.~ When Page is ON, choosing the VFO, the Call channel, ora memory channel does not affect the Page status. Pageremains ON.~ When Page is switched ON while DTSS is ON, DTSS isswitched OFF automatically.