Installing the Operating System with Express Setup 5-43Installing with the OEM-FD for Mass Storage DeviceThis section explains how to setup with the OEM-FD. You usually do not have to do as follows. Thedetailed information is provided by the manual of the Mass Storage Device.Installation of Mass storage device not to be supported by Express SetupIf you would like to install or re-install the OS when the system has new mass storage device not tobe supported by NEC EXPRESSBUILDER, you have to set as follows.1. Read the manual supplied with the mass storage device before setting the server.2. If the mass storage device is RAID Controller, configure the RAID system before runningthe NEC EXPRESSBUILDER.3. Boot the system from NEC EXPRESSBUILDER DVD.4. Select [Load the optional driver into the EXPRESSBUILDER] from the Top menu, andclick [Next].Set the driver disk for the mass storage controller, and press the [Perform] button.NOTE: By choosing this option, you can load the driver provided byCD-ROM or floppy disk to proceed with the Express Setup.5. Perform Express Setup with the following settings.(a) When "Enter RAID settings" appears, check "Skip the logical drive creation".(b) Check "Apply OEM-FD for Mass storage device".6. Copy the driver for the mass storage device in the Express Setup.Insert the floppy disk attached to the mass storage device into the floppy disk drive.Continue the Express Setup, referring to messages displayed on the display.
