Troubleshooting 8-3ERROR MESSAGESIf an error occurs in the CPU blade, an error message appears on the display unit connected to theCPU blade.POST Error MessagesPowering on the CPU blade automatically starts the self-diagnostic program, POST (Power On Self-Test). When the POST detects any error, it displays an error message and its measure on the displayunit.Follow the table below to troubleshoot such errors.IMPORTANT: Take a note on the messages displayed beforeconsulting with your service representative. Alarm messages are usefulinformation for maintenance.On-screen error message Action0200 Failure Fixed Disk Contact your service representative.0230 System RAM Failed at offset0231 Shadow RAM Failed at offset0232 Extend RAM Failed at address line0234 Single-bit ECC error0235 Multiple-bit ECC error0250 System battery is deadReplace and run SETUPContact your service representative toreplace the battery. (Restart the system,and then run the BIOS SETUP utility tocorrect the setting.)0251 System CMOS checksum badDefault configuration usedDefault configuration is used. Restart thesystem, and then run the BIOS SETUPutility to correct the setting.0260 System timer error Contact your service representative.0270 Real timer error0271 Check date and time setting Run the BIOS SETUP utility to set thedate and time. If the error persists,contact your service representative.02D0 System cache error Cache disabled Contact your service representative.0B1B PCI System Error on Bus/Device/Function0B1C PCI Parity Error on Bus/Device/Function0B28 Unsupported Processor detected on Processor 10B29 Unsupported Processor detected on Processor 20B50 Processor #1 with error taken offline0B51 Processor #2 with error taken offline0B5F Forced to use Processor with error
