5-4 Installing the Operating System with Express SetupSupported Options by NEC EXPRESSBUILDERThe NEC EXPRESSBUILDER DVD attached to your system supports the following options forinstallation.NOTE: If you want to install the other boards by using a driver floppydisk ("OEM-FD for Mass storage device"), except ones listed below,see "Installing with the OEM-FD for Mass storage device" and"Installing Optional Mass Storage Driver" of "Parameter File Creator"in Chapter 6. Options supporting installation of OS with Express Setup– N8403-018 Fibre Channel Controller– Storage and I/O Blade AD106a Other options– N8403-018 Fibre Channel Controller– Storage and I/O Blade AD106aNOTES: The driver of option card mentioned above is stored in the NECEXPRESSBUILDER DVD. If you use the board not mentioned above, the Express Setup willfail. Refer to the instructions attached to the board.About the Hardware ComponentsWhen you install the Windows Server 2008, Express Setup requires several preparations if thiscomputer uses the following hardware components.Installing on the Mirrored VolumeWhen re-installing the OS to a hard disk drive which has been upgraded to Dynamic Disk, only thesimple dynamic volume is available for installation.If you want to install the OS on a volume that is mirrored using Disk Management, invalidate themirroring and reset to the basic disk before the installation, and validate the mirroring again after theinstallation.You can create, invalidate, or delete the mirror volume by using Disk Management in ComputerManagement.
