NUM 1020 M Operator's Manual

Contents

Table Of Contents
Table Of Contents
Table Of Contents
System Overview
Machine Overview
Environment
Switching on/off
System Identification
NUM Panel and Sub-Assemblies
Interactions Between Mode Selections and Display Pages
Available Controls and Indicators
Special Keyboard Operations
Use of a 102/105-Key Keyboard with the Compact Panel
Inch/Metric Unit Conventions
Display of Shifts
Display of Tool Data and Tool Corrections
Display of Programmes
Display of a Programme in Graphic Mode
Display of Active Data
Display of Programme-Being Executed
Display of Programme Variables and Equivalent Address Table
Display of Inputs/Outputs
Access to Maintenance Functions
Preliminary Operations
Preparation for Machining
Manual Data Input
Automatic Programme Execution
Operator Interventions
CNC Information Archiving
Creation of a Part Programme
Inch/Metric Unit Selection
Part Programme Operations in Background Mode
Operational Problems
Indicator "FDHLD" Displayed
No Movement in Manual Mode
No Movement in Automatic Mode
No Cycle Start
No Block Sequencing
Faults Detected by the System
Power Failures
System Faults
Hardware Fault
Temporary Customisation
Sampling Period Too Small
Parameter Table Not Conforming to Software Version
A Declared Axis Missing
Not Enough Memory to Execute the Pocket Module
Incorrect Sampling Period with UC SII CPU
Incoherent QVN Sensor Address
Undeclared Speed Sensor Connected to the QVN Card
Speed and Position Sensor Declared on Several Axes
Several Axis Drive Sensors Have the Same Address
QVN Axes Missing
Sampling Period Not Within the Authorised Values
Hardware Maintenance
Accessing the Utilities
Serial Line Parameters
Customising the Colour Palette
Backing up Machine Data
Setting the Date and Time
Battery Management Update
Protected Memory Area Management
Customisation of the System
ISO Programming Syntax
Parametric Programming Syntax
Profile Geometry Programming (PGP Syntax
Miscellaneous Errors and Machine Errors
Parametric Programming Errors
Profile Geometry Programming (PGP Errors
Miscellaneous Errors
Structured Programming Errors
Errors in Pocket Cycles
Dynamic Operators in C
Cycle Programming Errors
CNC / Peripheral Interconnection
Connection to a Peripheral Device
Connection to a Computer

NUM 1020 M Operator's Manual Manual pdf 247 page image

en-938821/2 7 - 5System Faults77.1 Hardware FaultMessage displayed at initialisationPARAMETER TABLECHECKSUM ERRORCONTINUE (Y/N)?Commentlt is probably a hardware fault (faulty card, etc.).ActionsContact the NUM Service Engineer.7.2 Customisation ErrorMessage displayed at initializationOPTIONS NOT VALIDCONTINUE (Y/N)?CommentThis message should never be displayed: it would indicate an illegal attempt to modify the list of software options!!!ActionsAcknowledge the message. + YThe system is available, but the machining modes are inhibited.The system error indicator «PRSER» is displayed in the status window (See 3.1.3).Contact NUM.

/ 388

This manual is suitable for:

1020 M 1020 W 1040 M 1040 W 1050 M 1050 W 1060 M 1060 W

manualsdatabase

Your AI-powered manual search engine