NUM 1020 M Operator's Manual
                                                                                                                                                                                                                                                                                                                                                                                                    | |
Contents
| 
B - 8 en-938821/2B.8 Errors in Pocket CyclesError No. Meaning of the error260 Working memory busy261 Programme number too high262 NU number not among those authorised263 Execution impossible - Test or Graphic mode mandatory after first load or after editing264 No dimension programmed in the contouring plane or dimension outside the plane265 First positioning block missing; contour definition must begin with G0 or G1266 Not enough memory267 Character not allowed in pocket syntax268 Pocket programming block incomplete or containing illegal data269 Contour block incomplete / Positioning block missing before pocket definition270 Pocket definition partly or completely missing271 Tool orientation not perpendicular to the contouring plane272 Real tool not compatible with pocket technological data273 Change of contouring plane between pocket definition and machining274 Two nested pocket definitions275 NU0 programmed with G59276 Zero pocket depth277 Pocket definition start point or end point coordinates incomplete278 The spindle rotation direction is incompatible with the one required in the pocket definition279 G function not allowed in a pocket programming block280 First contour block incomplete281 Discontinuity in one of the contours described282 Pocket definition parameter error(s)283 The external contour must be unique and must exist284 Error in contour definition285 Too many contours286 Pass setting excessive with respect to the tool diameter287 Pass setting insufficient with respect to the dimensions288 Finishing infeed in an acute angle or an unroughed area: change the infeed point289 Tool diameter excessive290 Internal error291 Finishing infeed outside the contour292 Double positioning at the start of the contour293 Roughing end point present during facingB.9 Axes Not Identified on the BusError No. Meaning of the error300 to 309 ∗ Axis 0 to 9 declared in P2 but not detected on the bus310 to 319 ∗ Axis 10 to 19 declared in P2 but not detected on the bus320 to 329 ∗ Axis 20 to 29 declared in P2 but not detected on the bus330 and 331 ∗ Axis 30 and 31 declared in P2 but not detected on the bus∗ Machine error. Caution: For this type of error, a CNC reset causes a general reset (CNC reset + PLC reset) |
manualsdatabase
Your AI-powered manual search engine