7 - 14 en-938821/27.16 Speed and Position Sensor Declared on Several AxesMessage displayed at initialisationERROR: SPEED AND POSITION SENSORDECLARED ON SEVERAL AXESCONTINUE (Y/N)?CommentA sensor is declared as position sensor and speed sensor on at least two different axes in parameter P71 (SeeParameter Manual).ActionsAcknowledge the message. + YThe system is available, but the machining modes are inhibited and power cannot be applied to the system.The "PRSOV" system fault indicator is displayed in the status window (See 3.1.3).Enter correct sensor addresses in parameter P71 (See Parameter Manual).Reset the system to take the new parameter into account.7.17 Position Sensor Not Found on Axis Card and Not Declared as QVNSensorMessage displayed at initialisationERROR: POSITION SENSOR NOT FOUND ONAXIS CARD AND NOT DECLARED AS CONNECTEDTO QVN CARDCONTINUE (Y/N)?CommentThe system detects a sensor at initialisation, but the sensor is not connected to an axis card and is not declared inparameter P70 (See Parameter Manual).This means that the sensor is connected to a QVN card but is not declared as such.ActionsAcknowledge the message. + YThe system is available, but the machining modes are inhibited and power cannot be applied to the system.The "PRSOV" system fault indicator is displayed in the status window (See 3.1.3).Declare the sensor in parameter P70 (See Parameter Manual).Reset the system to take the new parameter into account.
