en-938821/2 7 - 9System Faults7! WARNINGIt is advisable to save the parameter table or make a paper printout each time the table ismodified (See Parameter Manual)The parameter table has not been savedThe message must not be acknowledged:Cut off the power supply to the system.Return to the previous system status (reinstall the old memory board).Restart the system.Save the parameters (See Parameter manual).Cut off the power supply to the system.Re-install the new software version.Restart the system and continue the procedure.7.7 A Declared Axis MissingMessage displayed at initialisationMISSING AXISDO YOU WANT TO CONTINUE ? (Y/N)CONTINUE (Y/N)?CommentOne of the axes declared in parameter P2 (See Parameter Manual) is missing.ActionsAcknowledge the message. + YThe system is available, but power cannot be applied to the machine.Enter the P2 parameter value corresponding to the axes present(See Parameter manual).If required, modify the other axis-related parameters in compliance withparameter P2.Reset the system to take the new parameters into account.
