● WLAN security mode — Select the encryptionused: WEP, 802.1x (not for ad hoc networks), orWPA/WPA2. If you select Open network, noencryption is used. The WEP, 802.1x, and WPAfunctions can be used only if the networksupports them.To enter the settings for the selected security mode,select WLAN security settings.Security settings for WEP● WEP key in use — Select the wired equivalentprivacy (WEP) key number. You can create up tofour WEP keys. The same settings must beentered on the WLAN access point device.● Authentication type — Select Open orShared for the authentication type betweenyour device and the WLAN access point device.● WEP key settings — Enter WEP encryption(length of the key), WEP key format (ASCII orHexadecimal), and WEP key (the WEP key datain the selected format).Security settings for 802.1x and WPA/WPA2● WPA/WPA2 — Select the means ofauthentication: EAP to use an extensibleauthentication protocol (EAP) plug-in, or Pre-shared key to use a password. Complete theappropriate settings:● EAP plug-in settings — Enter the settings asyour service provider instructs.● Pre-shared key — Enter a password. Thesame password must be entered on the WLANaccess point device.● WPA2 only mode — Only WPA2 enabled devicesare allowed to establish a connection in thismode.Advanced WLAN settingsSelect Options > Advanced settings and from thefollowing:● IPv4 settings — Enter the IP address of yourdevice, the subnet IP address, the defaultgateway, and the IP addresses of the primary andsecondary DNS servers. Contact your internetservice provider for these addresses.● IPv6 settings — Define the type of DNS address.● Ad-hoc channel (only for Ad-hoc) — To enter achannel number (1-11) manually, select Userdefined.● Proxy server address — Enter the address forthe proxy server.● Proxy port number — Enter the proxy portnumber.Packet data settingsPress , and select Tools > Settings >Connection > Packet data.The packet data settings affect all access pointsusing a packet data connection.174 Settings
