Chapter 3 Using the console interface 167Using the BayStack 380 10/100/1000 SwitchThe software download process automatically completes without userintervention. The process erases the contents of flash memory and replaces it witha new software image. Be careful not to interrupt the download process until afterit runs to completion (the process can take up to 10 minutes, depending onnetwork conditions).LED Indications during the download processDuring the software image download, the link and speed LEDs turn to green andbegin a browsing display pattern. The two rows of 10/100/1000 LEDs illuminatefrom in to out. After the download, the system automatically reboots and theLEDs return to the initialization state.TFTP Server IPAddressThe IP address of your TFTP load host.Default Value 0.0.0.0 (no IP address assigned)Range Four-octet dotted-decimal notation, where each octet is representedas a decimal value, separated by a decimal pointStart TFTP Loadof New ImageSpecifies whether to start the download of the switch software image (default is No).Use the spacebar to toggle the selection to Yes.Press [Enter] to initiate the software download process.NOTE: The software download process can take up to 60 seconds to complete (or moreif the load host path is congested or there is a high volume of network traffic).To ensure that the download process is not interrupted, do not power down the switch forapproximately 10 minutes.Default Value NoRange Yes, NoNote: If problems occur during the software download process, theSoftware Download screen displays error codes that define the problem.The error codes are described in Chapter 4, “Troubleshooting,” on page171.Table 38 Software Download screen fields (continued)Field Description
