Using the Console Interface309985-B Rev 00 3-9Table 3-2. IP Configuration/Setup Screen FieldsField DescriptionBootP RequestModeOne of four modes of operation for BootP. (See “Choosing a BootP Request Mode” onpage 3-10 for details about the four modes.)Default Value BootP DisabledRange BootP Disabled, BootP or Last Address, BootP When Needed, BootPAlwaysConfigurable Column header for the user-configurable fields in this screen. The data displayed in thiscolumn represents parameters that you can configure (or that are currently configured).In Use Column header for the read-only fields in this screen. The read-only data displayed inthis column represents data that is currently in use.Last BootP Column header for the read-only fields in this screen. The read-only data displayed inthis column represents data obtained from the last BootP reply received.In-Band Stack IPAddressThe in-band stack IP address field.Default Value 0.0.0.0 (no IP address assigned)Range Four-octet dotted-decimal notation, where each octet is representedas a decimal value, separated by a decimal pointIn-Band SwitchIP AddressThe in-band IP address of the BayStack 410-24T switch. This field is not required for theoperation of the stack. This field can not use the same IP address used for the stack.Default Value 0.0.0.0 (no IP address assigned)Range Four-octet dotted-decimal notation, where each octet is representedas a decimal value, separated by a decimal pointNote: When the IP address is entered in the In-Band IP Address field, and the In-BandSubnet Mask field value is not present, the software provides an in-use default value forthe In-Band Subnet Mask field that is based on the class of the IP address entered in theIn-Band IP Address field.In-Band SubnetMaskThe subnet address mask associated with the in-band IP address shown on the screen(see Note above). Network routers use the subnet mask to determine the network orsubnet address portion of a host’s IP address. The bits in the IP address that contain thenetwork address (including the subnet) are set to 1 in the address mask, and the bitsthat contain the host identifier are set to 0.Default Value 0.0.0.0 (no subnet mask assigned)Range Four-octet dotted-decimal notation, where each octet is representedas a decimal value, separated by a decimal point(continued)
