Introduction to the BayStack 410-24T Switch309985-B Rev 00 1-67Trunk Configuration Screen for Switch S2As shown in Figure 1-40 on page 1-63, switch S2 is set up with two trunkconfigurations (T2 and T3). Both trunks connect directly to switch S1. As in theprevious screen examples, to set up a trunk configuration choose MultiLink TrunkConfiguration from the MultiLink Trunk Configuration Menu screen.Figure 1-43 shows the MultiLink Trunk Configuration screen for switch S2.Figure 1-43. MultiLink Trunk Configuration Screen for Switch S2Switch S2 is configured as follows:• Trunk (read only) indicates the trunks (1 to 6) that corresponds to the switchports specified in the Trunk Members fields.• Trunk Members (Unit/Port) indicates the ports that can be configured, ineach row, to create the corresponding trunk:-- Ports 25 and 26 are assigned as trunk members of trunk 1.-- Ports 1 and 3 are assigned as trunk members of trunk 2.MultiLink Trunk ConfigurationTrunk Trunk Members (Unit/Port) STP Learning Trunk Mode Trunk Status----- ------------------------------- ------------ --------------- ------------1 [ /25 ][ /26 ][ / ][ / ] [ Normal ] Basic [ Enabled ]2 [ /1 ][ /3 ][ / ][ / ] [ Normal ] Basic [ Enabled ]3 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]4 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]5 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]6 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]Trunk Trunk Name----- ------------------1 [ S2:T2 to S1 ]2 [ S2:T3 to S1 ]3 [ Trunk #3 ]4 [ Trunk #4 ]5 [ Trunk #5 ]6 [ Trunk #6 ]Enter text, press or when complete.Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
