Introduction to the BayStack 410-24T Switch309985-B Rev 00 1-69Trunk Configuration Screen for Switch S3As shown in Figure 1-40 on page 1-63, switch S3 is set up with one trunkconfiguration (T4). This trunk connects directly to switch S1.As in the previous screen examples, to set up an inter-switch trunk configurationchoose MultiLink Trunk Configuration from the MultiLink Trunk ConfigurationMenu screen.Figure 1-44 shows the MultiLink Trunk Configuration screen for switch S3.Figure 1-44. MultiLink Trunk Configuration Screen for Switch S3Switch S3 is configured as follows:• Trunk (read only) indicates the trunk (1 to 6) that corresponds to the switchports specified in the Trunk Members fields.• Trunk Members (Unit/Port) indicates the ports that can be configured, ineach row, to create the corresponding trunk:Ports 1 and 3 are assigned as trunk members of trunk 1.MultiLink Trunk ConfigurationTrunk Trunk Members (Unit/Port) STP Learning Trunk Mode Trunk Status----- ------------------------------- ------------ --------------- ------------1 [ /1 ][ /3 ][ / ][ / ] [ Normal ] Basic [ Enabled ]2 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]3 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]4 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]5 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]6 [ / ][ / ][ / ][ / ] [ Normal ] Basic [ Disabled ]Trunk Trunk Name----- ------------------1 [ S3:T4 to S1 ]2 [ Trunk #2 ]3 [ Trunk #3 ]4 [ Trunk #4 ]5 [ Trunk #5 ]6 [ Trunk #6 ]Enter text, press or when complete.Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.