Using the BayStack 410-24T 10BASE-T Switch3-52 309985-B Rev 00Port ConfigurationThe Port Configuration screen (Figure 3-21 and Figure 3-22) allows you toconfigure specific switch ports or all switch ports. You can enable or disable theport status of specified switch ports, set (optional) MDA ports to autonegotiate forthe highest available speed of the connected station, and you can set the duplexmode for specific ports (autonegotiation is not supported on fiber optic ports).You can disable switch ports that are trunk members; however, the screen promptsfor verification of the request before completing the action. Choosing [Yes]disables the port and removes it from the trunk.Choose Port Configuration (or press p) from the Switch Configuration Menuscreen to open the Port Configuration screen.Figure 3-21. Port Configuration Screen (1 of 2)Note: The Autonegotiation fields, the Link Trap, the Speed fields, and theDuplex fields are independent of MultiLink trunking, rate limiting, VLANs,IGMP Snooping, and the STP.Port ConfigurationUnit: [ 1 ]Port Trunk Status Link LnkTrap Autonegotiation Speed Duplex---- ----- ------------ ----- ------- --------------- -----------------1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Half ]2 [ Enabled ] Up [ On ] [ Enabled ] [ 10Mbs / Full ]3 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Full ]4 [ Enabled ] Up [ Off ] [ Disabled ] [ 100Mbs / Half ]5 [ Enabled ] Down [ On ] [ Disabled ] [ 100Mbs / Half ]6 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]7 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]8 [ Enabled ] Down [ Off ] [ Disabled ] [ 100Mbs / Half ]9 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]10 [ Enabled ] Down [ On ] [ Disabled ] [ 100Mbs / Half ]11 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Half ]12 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Half ]13 2 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]14 2 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]More...Press Ctrl-N to display choices for additional ports..Use space bar to display choices, press or to select choice.Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.