Adding an ASA 310-FIPS to an Existing Cluster 63same cluster. When selecting Extended Security mode, this stepwill not appear.( new setup, continued)Enter a secret passphrase (it will be used duringaddition of new iSDs to the cluster):Re-enter to confirm:9 When the Setup utility has finished, log in to the ASA310-FIPS again and continue with the configuration.( new setup, continued) Initializing system......okSetup successful. Relogin to configure.login:The setup is now finished, and after a short while you will geta login prompt. Log in as the admin user with the passwordyou defined during the initial setup. The Main menu is thendisplayed. You can now continue with the configuration of theASA 310-FIPS using the command line interface (CLI). For moreinformation about the CLI, see “The Command Line Interface”(page 135).Note: After successfully having initialized the HSM cards,you are automatically logged in to each HSM card as USER.You can verify the current HSM card login status by using the/info/hsm command. After a reboot has occurred (whetherintentionally invoked, or due to a power failure), you mustmanually log in to the HSM cards for the ASA 310-FIPSdevice to resume normal operations. For more informationabout logging in to the HSM cards after a reboot, see “An ASA310-FIPS Stops Processing Traffic” (page 153).--End--Adding an ASA 310-FIPS to an Existing ClusterYou add additional ASA 310-FIPS units to an existing cluster by selectingjoin from the Setup menu in the ASA 310-FIPS, after it has booted.Nortel VPN GatewayUser GuideNN46120-104 02.01 Standard14 April 2008Copyright © 2007-2008 Nortel Networks.
