68 Initial Setup( join setup, continued)Verify that CODE-SO iKey (black) is inserted in card 1(with flashing LED). you used in Step 5 >Hit enter when done.Verify that HSM-USER iKey (blue) is inserted in card 1(with flashing LED).Hit enter when done.Verify that CODE-USER iKey (black) is inserted in card1 (with flashing LED). that you used in Step 5 >Hit enter when done.Wrap key successfully combined to card 1.7 If you selected FIPS mode when installing the first ASA310-FIPS in the cluster, provide the correct passphrase.If you selected FIPS mode when installing the first ASA310-FIPS in the cluster, you will also be asked to provide thepassphrase you defined at that time. If you selected ExtendedSecurity mode, this step will not appear.( join setup, continued)Enter the secret passphrase (as given duringinitialization of the first iSD in the cluster):8 Wait until the Setup utility has finished.( join setup, continued)Setup successful.login:The setup utility is now finished. The ASA 310-FIPS thathas now been added to the cluster will automatically pick upall configuration data from one of the already installed ASA310-FIPS units in the cluster. After a short while you will get alogin prompt.Note: After successfully having initialized the HSM cards,you are automatically logged in to each HSM card as USER.You can verify the current HSM card login status by using the/info/hsm command. After a reboot has occurred (whetherintentionally invoked, or due to a power failure), you mustmanually log in to the HSM cards for the ASA 310-FIPSdevice to resume normal operations. For more informationabout logging in to the HSM cards after a reboot, see “An ASA310-FIPS Stops Processing Traffic” (page 153).Nortel VPN GatewayUser GuideNN46120-104 02.01 Standard14 April 2008Copyright © 2007-2008 Nortel Networks.
