Notifier AFP-200 Installation Manual

Also see for AFP-200: Manual Instruction manual Manual

Contents

Notifier AFP-200 Installation Manual Manual pdf 30 page image

Installation Preparing for Installation30 AFP-200 PN 15511:H2 10/14/2002Section 2 Installation2.1 Preparing for Installation2.1.1 Unpacking the SystemCarefully unpack the system and inspect for shipping damage.Select a location for the control panel in a clean, dry, vibration-free area with moderatetemperature.2.1.2 Installation NotesBefore installing the fire alarm system, read the following:• Install the system in a readily accessible area with sufficient room to easily installand maintain the control panel.• Locate the top of the cabinet approximately 60 inches (1.524 m) above the floorwith the hinge mounting on the left.• Count the number of conductors needed for all devices and find the appropriateknockouts.• Review the installation precautions at the front of this manual.• All wiring must comply with the National and/or Local codes for fire alarmsystems.• Do not draw wiring into the bottom 9 inches (22.86 cm) of the cabinet, exceptwhen using the BB-17. This prevents interference between the power supply andbatteries.2.1.3 Standards and CodesIn addition, installers should be familiar with the following standards:• NEC Article 300 Wiring Methods.• NEC Article 760 Fire Protective Signaling Systems.• Applicable Local and State Building Codes.• Requirements of the Local Authority Having Jurisdiction.Technical Manuals Online! - http://www.tech-man.com