CS240 5-67Network settings 55.12 SNMP settingsSpecify SNMP settings. Settings can be specified for the following.SNMP Setting screen 1/3SNMP Setting screen 2/3SNMP Setting screen 3/3!DetailIf an IP address or IPX address is specified with "Status Notification Setting", use the TRAP functionwith SNMP. Set "TRAP Setting" on the SNMP Setting screen to "Allow".For details on "Status Notification Setting", refer to "Status notification setting" on page 5-83.1 Touch [5 Network Setting] in the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to "Displaying the administratorsettings screen" on page 4-6.2 Touch [8 SNMP Settings] in the Network Settings screen.SNMP Setting screen 1/3 appears.3 To enable the SNMP settings, touch [ON], and then specify the desired settings.– Select the desired settings, and then touch [OK].Parameter DescriptionSNMP v1/v2c (IP) Select whether or not SNMP v1/v2c (IP) is used.SNMP v3 (IP) Select whether or not SNMP v3 (IP) is used.SNMP v1 (IPX) Select whether or not SNMP v1 (IPX) is used.Parameter DescriptionUDP Port Number Specify the UDP port number. To change the setting, press the [C] (clear) key, andthen use the keypad to type in the desired port number. (Range: 1 to 65535)SNMP v1/v2c Settings Specify the settings when v1 or v2c is selected. For details, refer to "SNMP v1/v2csettings" on page 5-68.SNMP v3 Settings Specify the settings when v3 is selected. For details, refer to "SNMP v3 settings"on page 5-70.Parameter DescriptionPermission Settings Select whether to permit or prohibit TRAP.TRAP Setting When Authentica-tion FailedSelect whether or not to enable TRAP when authentication failed.
