CS240 5-83Network settings 55.18 Status notification settingSpecify settings for sending notification of the machine’s status by e-mail to the administrator. The statusnotification is sent if a notification destination e-mail address is entered and if any of the notificationconditions have been set to "ON".The following notification addresses can be specified.- IP address- IPX address- E-mail address2 NoteUp to five IP addresses can be specified.If an IP address or IPX address is to be specified, use the TRAP function with SNMP. Set "TRAPSetting" on the SNMP Setting screen to "Allow".For details on "SNMP Settings", refer to "SNMP settings" on page 5-67.Specifying an IP addressSettings can be specified for the following.1 Touch [5 Network Setting] in the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to "Displaying the administratorsettings screen" on page 4-6.2 Touch [Forward ] in the Network Settings screen, and then touch [1 Detail Settings].3 Touch [3 Status Notification Setting].The Status Notification Setting screen appears.4 Touch [1 Notification Address Setting].The Notification Address Setting screen appears.Parameter DescriptionAddress Specify the notification host address.Port Number Specify the port number to be used for communication. To change the setting,press the [C] (clear) key, and then use the keypad to type in the desired portnumber. (Range: 1 to 65535)Community Name Type in the community name (15 characters or less).Notification Item Specify the conditions when notification of the machine’s status is sent. For de-tails, refer to "Notification item" on page 5-88.
