VL6522c/VL5522c/VL4522c 9-139.2 One-Touch/User Box Registration 9Reference- If Active Directory is used for user authentication, press [Home] that appears on the touch panel to allowyou to easily send scanned data to your own Home folder. For details, refer to page 5-22.- To check a registered destination, select its registered name, and then press [Check Job Set].- To change the settings for a registered destination, select its registered name, and then press[Edit].- To delete a registered destination, select its registered name, and then press [Delete].Item DescriptionNo. Press [No.], and then enter the registration number of the destination be-tween 1 and 2,000. Press [OK] without entering any number to register thesmallest number available.Name Use the touch panel to enter the name to be registered in the address bookusing up to 24 characters.User ID Enter the user ID for logging into the destination computer via the touch panel(up to 127 characters).• If user authentication settings have been applied, you can avoid register-ing a password on the screen for registering a new PC (SMB) destinationand enhance security by using the user ID and password included in userregistration information. If this is the case, leave the User ID and Pass-word boxes blank. In addition, set "Scan to Authorized Folder Settings"in Administrator Settings to "Limit". For details on setting this function, re-fer to the "User's Guide [Network Administrator]".Password Enter the password for logging into the destination computer via the touchpanel (up to 14 characters).Host Address Enter the host name, IPv4 address or IPv6 address as the host address forthe destination computer.The host name must be less than 255 characters in length.• If you enter a host name and then select to enter an IP address, the hostname is cleared.• If you enter an IP address and then press [Input Host Name], the IP ad-dress is cleared.• Host name and file path must be specified in uppercase.• To perform SMB transmission using an IPv6 address, set the Direct Host-ing to "ON". For details, refer to the "User's Guide [Network Administra-tor]".File Path Enter the destination file path for saving data via the touch panel (up to 255bytes).Reference Allows you to detect a computer on the network and register a shared folderas a destination.• If the number of computers or workgroups on the network (subnet) towhich this machine is connected exceeds the value shown below, thestructure of the folders may not be properly reference.Workgroups: 512Computers: 512The structure of the folders cannot be referenced in the IPv6 environment.Index Select the index. For a frequently used destination, specify the index charac-ters and select [Favorites] at the same time. This allows you to find it moreeasily.Icon Select an icon.• The selected icon is used for the image panel function that is availablewhen the optional function code "CAA" is enabled.
