VL6522c/VL5522c/VL4522c 12-712.3 Error messages displayed 1212.3 Error messages displayedIf the machine encounters a problem, an error dialog will appear and display one of the following errormessages. Take corrective actions by referring to the table below.If a communication error persists, please contact your service representative.12.3.1 G3 Fax12.3.2 If the HDD Ready indicator indicates an HDD malfunctionContact your service representative.Error Message Corrective ActionsFailed to complete thejob due to an error whiledialing.Redial was attempted the number of times specified, however, transmissionfailed because the recipient was busy or due to other reasons.Check the recipient's state to resend the fax.Unable to check sender The machine failed to verify the recipient with Check Dest. & Send set to[ON].Check that the receiver's fax number is registered correctly.The job has been deleteddue to insufficient mem-ory.During scanning of original, the memory became full.Press [Start] to send scanned originals. Press [Stop] to stop faxing.Job FailedCheck the line connec-tion.The telephone cord may have become unplugged.Check the telephone cord for connection and, if unplugged, plug it securely.Cannot connect to thenetworkMake sure that the network cable is correctly connected. In addition, makesure that "Network Settings" in Administrator Settings is correctly config-ured.The destination cannotbe selected because thenumber of destinationshas exceeded the max.number of broadcastingpossibleThe number of destinations specified exceeds the number possible for abroadcast transmission. Reduce the number of broadcast destinations, orsend the transmission in multiple batches.Document could not besaved in the User Boxdue to insufficient HDDcapacity. Check log.The hard disk is full. Delete unnecessary data, and then try saving the dataagain.The number of registeredUser Boxes has reachedthe maximum allowedThe number of User Boxes that can be registered has reached the maximumnumber possible. Delete unnecessary User Boxes, and then try registeringnew boxes again.This user box hasreached its maximumnumber of pages al-lowed.The number of documents that can be saved in a User Box has reached themaximum number possible. Delete unnecessary documents, and then trysaving the document again.The maximum number ofjobs has been queued.Wait until a queued job iscompleted.The number of jobs that can be programmed has reached the maximumnumber possible. Wait until a job has been completed, or delete a current job.
