To begin operation44-4 VL6522c/VL5522c/VL4522c4.1Network settingsAn IP address must be assigned to the machine and settings, such as the SMTP server, must be specified inorder to use the machine on the network. For the detailed procedure, refer to the "User's Guide [NetworkAdministrator]".Specifying an E-mail address for this machineAn E-mail address must be registered to this machine to send scanned data via E-mail or to use the InternetFax function. This E-mail address is used for sending/receiving data. It is recommended that the E-mailaddress registered for the administrator be used.If the E-mail address registered for the administrator is not specified, the sender's E-mail address must beentered for each Scan to E-mail operation. Note that Scan to E-mail operations are not possible if a Fromaddress is not entered.Reference- If User Authentication is enabled, the E-mail address specified for each user will be From address.d ReferenceFor details on setting the E-mail address for this machine, refer to the "User's Guide [Network Administrator]".4.1.3 Connection of modular cableTo send/receive G3 fax that use the telephone line, connect the modular cable to this machine. To use theG3 fax function, the optional fax kit FK-502 must be installed onto the machine. To use two telephone lines,one more optional fax kit FK-502 must be installed onto the machine. In this case, two modular cables mustbe connected.Connect one end of the modular cable to the telephone adapter, and the other end to the predeterminedconnector of this machine. For details on the connector location, refer to the "User's Guide [CopyOperations]".