- 126 -5. Operating Management/ Specifications• Drum Cleaning• Hex DumpColor MenuSystem Configuration MenuPCL SetupItem FactorydefaultsettingDescriptionDrum Cleaning OFF Sets whether to clean the drum before printing. The imagequality improvement may be expected.Item FactorydefaultsettingDescriptionHex Dump OFF Prints out the data received from the host computer in hex. Tofinish printing, turn off the machine.Item FactorydefaultsettingDescriptionDensity Control Auto Select "Auto" or "Manual" for adjusting density.Adjust Density - Adjusting density is performed right after this menu is selected.Color Tuning / Print Pattern - A test page is printed for checking the adjusting value to beentered for any other C/M/Y/K Tuning menus.Cyan Tuning Cyan Highlight 0 Adjust the value for Highlight / Mid-tone / Dark of each colorwithin a range of -3 to +3.+ : Adjusted to be darker.- : Adjusted to be lighter.Cyan Mid-Tone 0Cyan Dark 0Magenta Tuning MagentaHighlight0Magenta Mid-Tone0Magenta Dark 0Yellow Tuning Yellow Highlight 0Yellow Mid-Tone 0Yellow Dark 0Black Tuning Black Highlight 0Black Mid-Tone 0Black Dark 0Color Density Cyan Density 0 Adjust the total density of each color within a range of -3 to +3.+ : Adjusted to be darker.- : Adjusted to be lighter.MagentaDensity0Yellow Density 0Black Density 0Adjust Registration Color registration adjustment is performed.Ink Simulation OFF Sets the ink simulation. This setting is enabled only for PSlanguage jobs.UCR Low Adjusts the level of under color removal.CMY100% Density Disable Selects whether to use halftone for C, M, Y 100% density.CMYK Conversion ON Selects whether to use simple (quick) mode when performingCMYK Conversion.This menu setting is disabled if using the ink simulation function.Item FactorydefaultsettingDescriptionPersonality Auto Selects the emulation mode. If auto is set, the correct emulationis automatically selected every time a print job is received.Alarm Release Manual If [Manual] is set, non-critical warnings, such as requests for adifferent paper size, can be cleared by pressing [RESET]. If[Auto] is set, the warnings are cleared when the print jobresumes.Auto Continue OFF Sets whether the machine automatically recovers from amemory overflow.Error Report OFF Sets whether to print error details if PostScript, PCL6 or XPSerrors occur.Item FactorydefaultsettingDescriptionFont Source Resident Selects the location of the font to use.Item FactorydefaultsettingDescription
