- 45 -2. PrintFor Windows PS Printer Driver1 Close the rear output tray.2 Open the file to print.3 Select [Print] from the [File] menu.4 Click [Preferences].5 Select [Flip on Long Edge] or [Flip on Short Edge] from [Print on Both Sides]on the [Layout] tab.6 Change other settings if necessary, and then click [OK].7 Click [Print] on the [Print] screen.For Mac OS X1 Close the rear output tray.2 Open the file to print.3 Select [Print] from the [File] menu.4 Select [Long-Edge binding] or [Short-Edge binding] from [Two-Sided] on the[Layout] panel.5 Change other settings if necessary, and then click [Print].If setting details are not displayed in the print dialog, click [Show Details] at the bottom of the dialog.• For Windows PCL Printer Driver• For Windows PS Printer Driver• For Mac OS XPrinting is possible with less toner.The amount of toner can be saved in three levels.• [Printer setting]: Conforms to the printer setting.• [Off]: Prints at a normal density without saving toner.• [Save Level Low]: Prints at a somewhat lower density level.• [Save Level Middle]: Prints at a low density.• [Save Level High]: Prints at a very low density.If using this function, only [Normal (600x600)] or [Fast (600x600)] can be specified as the print quality.The density of the image that is printed with this function may vary depending on the printed document.For Windows PCL Printer Driver1 Open the file to print.2 Select [Print] from the [File] menu.3 Click [Preferences].4 Select the [Setup] tab.5 Select the amount of toner to save from [Toner saving].6 Change other settings if necessary, and then click [OK].7 Click [Print] on the [Print] screen.Saving Toner
