- 78 -5. Management / Setting the PrinterChanging the Printer SettingsThis section explains the basic procedure to change the equipment settings.• Administrator Setup Menu• Other Setup Menu• Print Statistics• Boot Menu• Setup the Buzzer• Hiding the paper size confirmation message• If a Power Failure OccursThis section describes how to change the settings of the printer as an Administrator.1 Press the scroll button several times to select [Admin Setup] and thenpress the «ENTER» button.2 Enter the administrator password using the numeric (0-9) keys, and then pressthe «ENTER» button.The factory default password is “123456”.3 Press the scroll button or to select the setup menu on which you wantto change a setting and then press the «ENTER» button.4 Press the scroll button or to change the setting.5 Press the «ENTER» button.6 Press the «ON LINE» button to exit the menu mode.• Network SetupAdministrator Setup MenuItem Factory Default DescriptionEnabling Default Gateway(When Wireless LAN is installed)Wired Selects a connecting method between differentsegments.Wired Enable Sets whether to enable wired LAN.TCP/IP Enable Sets whether to enable TCP/IP.NetBIOS over TCP Enable Sets whether to enable NetBIOS over TCP.IP Address Set Auto Sets the setting method of IP address.IPv4 Address ***.***.***.*** Sets the IP address. This item is displayed when [IPAddress Set] is [Manual].Subnet Mask ***.***.***.*** Sets the Subnet Mask. This item is displayed when [IPAddress Set] is [Manual].Gateway Address ***.***.***.*** Sets the Gateway Address. This item is displayed when[IP Address Set] is [Manual].DHCPv6 Disable Selects enable / disable of DHCP when IPv6 is used.Web Enable Enables/disables to access to the web page of theprinter.Telnet Disable Sets whether to enable Telnet.FTP Disable Sets whether to enable FTP.
