Frame-Assy-TRSpringSpringLatch4.2.2 Roller-Transfer(1) Open the Stacker Cover.(2) Remove the ID UNIT.(3) Take the Frame-Assy-TR out of the printer.(4) Disengage the latches of Bearing-TR ① on both ends.(5) Hold the Bearing-TR ① on the both side, and then lift up the Roller-Transfer ② .(At this moment, Gear-TR ③ is also removed.)(6) Assembling is performed by the inverse procedure with removing.(Note on removing / assembling)1. While assembling, pay attention to the up-and-down direction ofBearing-TR ① .2. Operating carefully, not to touch Roller-Transfer ② surface.3. Be careful not to fit each Bearing-TR ① to the Frame-Assy-TR withtheir springs inclined.4. The each Bearing-TR and Spring are common. After assembled, strongthe gear side pressure.4-54. REPLACEMENT OF PARTS
