4.2.9 Hopping / MPT / Regist Clutch(1) Remove the CU-Board. (Refer to 4.2.6)(2) Remove the Power-Supply Unit ( Board ). (Refer to 4.2.7)(3) Remove the DC Motor. (Refer to 4.2.8)(4) Remove the Sheet-Insulation-CU ① .(5) Remove the two screws (Silver) ② ,remove the Plate-Base(PWU)-A ③ .(6) Remove the two screws (Black) ④ ,remove the Plate-Clutch-MPT ⑤ .(7) Remove the MPT Clutch ⑥ and the Gear-MPT ⑦ .(8) Remove the four screws (Silver) ⑧ ,remove Plate-Gear ⑨ .(9) Remove the Gear-Reduction ⑩ .(10) Remove the E-ring ⑪ ,remove the Regist Clutch ⑫ .(11) Remove the E-ring ⑬ ,remove the Hopping Clutch ⑭ .(12) Assembling is performed by the inverse procedure with removing.(Note on removing / assembling)1. Beware of not to touch the DC motor inattentively (Do not rotate motor). 4-124. REPLACEMENT OF PARTS
