4.2.17 Cover Assy Rear(1) Remove the Cover-Side-R and Cover–Side-L. (Refer to 4.2.4 / 4.2.5)(2) Remove the CU-Board. (Refer to 4.2.6)(3) Remove the Sheet-Insulation-CU. (Refer to 4.2.9)(4) Remove the Spacer ① .(5) Slide Cover Assy Rear ② and pull it out of the hole on the right of theprinter.(Remove Cover Assy Rear ② carefully to avoid Cable-Sensor-FU ③ frombeing caught.)(6) Remove the two screws (Black) ④ and separate Cover-Rear ⑤ andGuide-Eject-Upper-Assy ⑥ .(7) Remove the Gear-Idle ⑦ .(8) Remove the Gear-Exit ⑧ (2 places), remove the Bearing-Eject_R ⑨ (2places). Remove the Bearing-Feeder ⑩ .(9) Remove the Shaft-Assy-Eject ⑪ (2 places).(10) Remove the Separator-FU ⑫ . Remove the Spring-Separator_FU ⑬ andBearing-Feeder ⑭ .(11) Remove the Stacker-Sensor ⑮ . Remove the Cable-Sensor-FU ⑯ .(12) Assembling is performed by the inverse procedure with removing.(Note on removing / assembling)1. Beware of not to touch the DC motor inattentively (Do not rotate motor).4-194. REPLACEMENT OF PARTS
