4.2.8 DC Motor(1) Remove the Plate-Shield. (Refer to 4.2.6)(2) Remove the Power Supply Unit ( Board ) and Sheet-Insulation-LV.(Referto 4.2.7)(3) Disconnect the cable and remove the screw(Silver) ① , remove theSwitch-Assy ② .(4) Remove the screw(Silver) ③ , remove the Duct-FAN-Power ④ .(5) Remove the cable of DC Motor ⑤ from CU-board.(6) Remove the three screws(Sliver) ⑥ ,remove the DC Motor ⑤ .(7) Assembling is performed by the inverse procedure with removing.(Note on removing / assembling)1. Beware of not to touch the DC motor inattentively (Do not rotate motor). 4-114. REPLACEMENT OF PARTS
