Oki LE840DT User Manual

Also see for LE840: Technical reference

Contents

2. PRINTER SETUP2.6 Printer SettingE2-212.6.2 Parameter Setting(Cont.)(10) WEB PRINTERSelect whether to use the printer as a web printer.When the web printer is enabled, the status of the printer connected toa network can be monitored through the web browser. OFF Disables web printer function ON INTERNAL Enables web printer function (using internalmemory) ON EXTERNAL Enables web printer function (using an externalusb memory)(11) RBN NEAR ENDSelect the remaining ribbon length when the ribbon near end isdetected. OFF Ribbon near end is not detected. 30m Ribbon near end is detected when the remainingribbon is 30-m long. (Equivalent to ribbon diameterof 38 mm) 70m Ribbon near end is detected when the remainingribbon is 70-m long. (Equivalent to ribbon diameterof 43 mm)(12) EX.I/OSelect the type of expansion I/O interface operating mode. Thisparameter needs to be set depending on the expansion I/O controlspecification of the device to be connected via the expansion I/Ointerface. TYPE1 Standard mode TYPE2 In-line mode(13) LBL/RBN ENDSelect the operation to be performed when a label end or ribbon end isdetected. TYPE1 When a label/ribbon end is detected in the middle ofprinting, the printer immediately stops printing. TYPE2 Selectable only when the ribbon saving function isnot activated.When a label/ribbon end is detected in the middle ofprinting, the printer prints the half-finished label asfar as possible, and stops when the next label is at thehome position.(14) MAXI CODESelect the Maxicode specification. TYPE1 Compatible with the current version TYPE2 Special specificationNOTE:The type specified by thecommand may differ from theactual mode, depending on thestatus of this parameter. Also,the data transmission method isslightly different.For details, refer to the ExternalEquipment Interface Manual.NOTE:Since detecting the remainingribbon length has a margin oferror, use the specified length asa guide.