2. PRINTER SETUP2.9 Position and Print Tone Fine AdjustmentE2-572.9.1 Fine Adjustment (Cont.) (8) RBN ADJ.When the ribbon is slack or wrinkled and printing is affected, fineadjust the ribbon motor torque.(9) THRESHOLD When you perform a threshold setting for the reflective sensor (Blackmark sensor) and found the threshold needs to be adjusted, set a fineadjustment value.This menu is accessible directly from the Threshold Setting Mode so thatthe threshold can be manually set right away.Manually set threshold = Peak voltage – The value set hereFor details, refer to Section 2.10.(10) THRESHOLD When you perform a threshold setting for the Transmissive sensor (Gapsensor) and found the threshold needs to be adjusted, set a fine adjustmentvalue. This menu is accessible directly from the Threshold Setting Modeso that the threshold can be manually set right away. .Manually set threshold = Peak voltage – The value set hereFor details, refer to Section 2.10.+10-15+9-14HighLowMotor torqueNOTE:When “0.0 V” is set for thisparameter, it is automaticallycorrected to 1.4V (default)after the power is turned OFFthen ON.NOTE:When “0.0 V” is set for thisparameter, it is automaticallycorrected to 1.0V (default)after the power is turned OFFthen ON.4.0V0.0V3.9V0.1V4.0V0.0V3.9V0.1VNOTE:1. The fine adjustment value isnot effective for the reverserotation.2. The all fine adjustmentvalues are applicable toevery print speed.
