Oki LE840DT User Manual

Also see for LE840: Technical reference

Contents

2. PRINTER SETUP2.6 Printer SettingE2-302.6.9 System Mode How to enter the System ModeThe System Mode consists of the following menus.<1>DIAG.Used to check and print the printer system information andmaintenance counter status.<2>PARAMETER SET ( Section 2.6.2)Used to set the parameters for each printer function.<3>ADJUST SET ( Section 2.9)Used to fine adjust the print position, cut position, print tone, etc.<4>TEST PRINTUsed to perform print tests.<5>SENSOR ADJUSTUsed to check the sensor statuses and set each sensor.<6>RAM CLEARUsed to perform a RAM clear. DO NOT USE this menu.<7>INTERFACE ( Section 2.6.10)Used to set the interface parameters.<8>BASIC ( Section 2.6.4)Used to set the function of basic program when it is loaded to theprinter.<9>FOR FACTORYUsed for an in-process inspection. DO NOT use this menu.<10>RFIDUsed to set RFID related parameters. ( see Installation Manual in eachRFID kit)<11>RTC ( Section 2.6.11)Used to set the date and time of the real time clock, enable or disablethe low battery check, and choose a real time renewal timing.<12>Z-MODE ( Section 2.6.5)Same as BASIC<13>USB MEMORY ( Section 2.6.12)Used to copy data to/from USB memory.<14>RESETUsed to reboot the printer.Power OFF System ModePower ON while holding down[FEED]&[PAUSE]Power ON while holding down[MODE]How to exit the User System ModeSelect <14>RESET menu to reboot the printer.