45641001TH Rev.1 6-29 /Oki Data CONFIDENTIAL6.2.9 License re-registration using the one-time dongle[1] Re-registration when the board is replacedThe license registered using the one-time dongle can be re-registered only in the sameequipment. When the SYS board or SRAM board (for SYS board) is replaced, follow theprocedures for re-registration given below.(1) Start up with the Setting Mode (08).(2) Enter the password, and then press the [OK] button.(If the password is not set for Service, press the [ENTER] button without enteringanything.)(3) Key in [3840], and then press the [START] button.(4) Press the [INSTALL] button.(5) Install the one-time dongle in the equipment (the one which you used for registeringthe selected license), and then press the [OK] button.(6) Select the license to be installed, and then press the [INSTALL] button.(7) The screen for notifying that the installation will be started is displayed. Then press the[YES] button.(8) After 10 to 40 seconds have passed, the screen for notifying the success of theperformance is displayed. Then press the [OK] button. If the screen for notifying afailure of the performance is displayed, quit this operation by pressing the [CLOSE]button. Then check that the one-time dongle, which you used for uploading theselected license, is installed in the equipment.(9) Check that the installed license is displayed on the license list.Remarks:If there are any other licenses to be returned, repeat from step (4). If there are no otherlicenses to be returned, press the [CLOSE] button, and then turn the power OFF.Notes:This procedure is available only with the one-time dongle used for the previous registration,since the model information registered in it is utilized. Use the same one-time dongle andthe equipment when registering the license.[2] Re-registration when the equipment is replaced due to malfunctionWhen the equipment has to be replaced due to a malfunction, return the license registeredin the equipment to the one-time dongle and register it to the new equipment following theprocedure below.Notes:The license of the IPSec Enabler (GP-1080) cannot be reinstalled. The one-time dongle tobe used is the one for the previous registration of the license. The license is deleted fromthe equipment and is stored in the one-time dongle.Do not perform the deletion of PDFA Converter since it is deleted without any return to theone- time dongle.(1) Start up with the Setting Mode (08).(2) Enter the password, and then press the [OK] button.(If the password is not set for Service, press the [ENTER] button without enteringanything.)(3) Key in [3840], and then press the [START] button.(4) Select the license to be returned, and then press the [REMOVE] button.(5) Install the one-time dongle in the equipment (the one which you used for uploading theselected license), and then press the [OK] button.
