|
45641001TH Rev.1 4-3 /Oki Data CONFIDENTIAL4.1.3 Image dimensional adjustment in the copy/printer/fax function[1] Reproduction ratio adjustment of primary scanning directionThe reproduction ratio in the primary scanning direction of the printed image can beadjusted as follows: Mode (05)>Code Function Remarks7000 PPC The larger the value is, the larger the reproduction ratio in theprimary scanning direction becomes.(0.1%/step)Acceptable values: 0 to 255 (Default: 128)7001 PRT/FAX The larger the value is, the larger the reproduction ratio in theprimary scanning direction becomes.(0.1%/step)Acceptable values: 128 to 255 (Default: 128)Make a test copy and compare the image obtained with the current settings; if necessary,make adjustments according to the following procedure:Notes:• Since the reproduction ratio may vary due to expansion and contraction of the paperimmediately after the image is printed out, it is recommended to measure its dimensionafter at least 3 minutes have passed.• This adjustment may cause image troubles such as moire, disappearance or breakingof thin lines on the printed image. Therefore check if there is no such image troublewhile you are performing the adjustment.(1) While pressing [0] and [5] simultaneously, turn the power ON.(2) Key in a code and press the [START] button.(3) Key in the adjustment value. (To correct a value, press the [CLEAR] button.)(4) Press the [OK] or [INTERRUPT] button to store the value. -> The equipment goes backto the ready state.(5) Make a test copy and check the image copied. To check the printed image, turn off thepower and then back on, and then print the image. If the image is not in the desiredreproduction ratio, repeat steps (2) to (4).
|
