45641001TH Rev.1 9-2 /Oki Data CONFIDENTIAL9.1.3 Backup filesThe following files are saved in the root directory of the USB device by backing up.Filename RemarkModelname_MFPSerialNo_yyyy-MM-dd_hh-mmE.g.: When backup was performed at 13:59 onOctober 1st, 2010.T290_CUK911379_2010-10-01_13-599.1.4 Cloning procedure[a] Backup procedure(1) Press the [ON/OFF] button to shut down the equipment.(2) Connect the USB device [1] to the USB port [2] on the right upper cover.[2][1]Fig. 9-3Notes:Backing up cannot be performed with multiple USB device [1] connected at thesame time.(3) Turn the power ON while pressing [6] and the [CLEAR] button simultaneously.(4) When “SRAM Clear Mode” appears on the LCD, key in [0] to select “0. Set SerialNumber” and then press the [START] button.(5) Key in the serial number on the label attached to the rear cover of the equipment, andthen press the [OK] button.(6) “Serial Number Setting completed” is displayed.(7) Turn the power OFF.(8) Turn the power ON while pressing the [5] and [9] buttons simultaneously.(9) Enter the password, and then press the [OK] button.(If the password is not set for Service, press the [ENTER] button without enteringanything.)(10) Select “1. Backup SRAM Data to USB”, and then press the [START] button.(11) Enter a password (max. 15 characters) set for the backup data.(12) “Backup Successfully done Restore the MFP” is displayed on the LCD screen whenthe backup has been properly completed.(13) Press the [ON/OFF] button to shut down the equipment.
