Oki Microline 8810 User Manual

Also see for ML8810: Setup guide Installation instructions Brochure Safety & warranty Hardware installation instructions

Contents

Microline 8810 Userís Guide50Applies to continuous forms fed through the optional Rear PushTractor.Adjusts the set horizontal location for printing the first characteron a form when using manual feed from the platform. Selectablesettings: Left 10, Left 9, Ö Left 2, Left 1, Right 1, Right 2 Ö Right9, Right 10, in increments of 1/180 inch (0.14 mm).The default is 0.Align1 Pos. Adj.Align2 Pos. Adj.Align3 Pos. AdjAlign4 Pos. Adj.Note To use this setting, The corresponding Align 1/ Align 2/Align 3 / Align 4 setting must be selected for Auto Align orAuto Align (POW).Use these to set up to four custom values for the left margin onforms when you are using manual feed from the platform. Thisrepresents the distance from the left edge of the page to the leftside of the first printed character. Adjusts within a range of 0 to45.4 mm, in 1/90-inch [0.26 mm] increments.The default setting is 5.1 mm.Auto AlignApplies only to manual feed from the platform.When Auto Align is engaged (the printer default), you can usethe front panel switches to change to a different preset leftmargin value (Align 1, 2, 3, or 4). The values are set in the menuunder Align1 Pos. Adj., etc.This lets you quickly switch to another form which requires adifferent left margin. For more information on using the frontpanel to change Align settings, see page 11.If MemoryAutoAlign (see page 60) is set to Valid [the default],whichever Align setting you last used will be saved in memoryand engaged the next time you turn on the printer.Note This setting does not apply when the printer initializes inresponse to an I-PRIME signal.