Microline 8810 Userís Guide53Busy LineApplies only when the optional RS-232C Serial Interface isinstalled.Selects which line your system monitors for a busy signal if theReady/Busy protocol (the default) s engaged. Set SSD- [thedefault], SSD+, DTR, or RTS.Busy TimeApplies only when the optional RS-232C Serial Interface isinstalled.Sets the length of the busy signal when the Ready Busy protocol(the default) is engaged. Select 200 milliseconds [the default],or 1 second.BuzzerThe default is Enable. Change to Disable to turn off the printerísaudible alarm.Buzzer VolumeChoose the volume of the buzzer: Low [the default], Middle, orHigh.Character SetChoose the Character Set: Set I [the default], Set II, Standard,Line Graphics, or Block Graphics (available only when the OKi MLemulation is selected).Check Print AreaApplies to manual feed from the platform with Auto Alignmentenabled. Determines whether or not data which is outside thenormal print area specified for the page prints.The default is Valid: data overflow does not print. This preventssuch data from printing on the platen.Caution! If you change this setting to Invalid, data couldprint directly on the platen and damage the printhead.Code PageChoose the Code Page character set you wish to use: USA [thedefault], Canada French, Multilingual, Portugal, Norway,BRASCII, Abicomp, Multilingual 858, or ISO 8859-15.