Oki Microline 8810 User Manual

Also see for ML8810: Setup guide Installation instructions Brochure Safety & warranty Hardware installation instructions

Contents

Microline 8810 Userís Guide55The default is Power Up. Change the setting to Select if the DTRsignal is required when the printer is selected.Eject DirectionApplies only if the optional CSF is installed.Change to FF Code if you want the printer to eject a cut sheetwhen it receives the FF command.Eject Dir.Choose where the paper is ejected when you are using manualfeed from the platform or the optional CSF(s): Front [thedefault] or Rear.Emulation ModeChoose the printer emulation: IBM PPR [the default], , Epson FX,or ML (Oki Microline).ESC SI PitchIBM emulation only.Sets the character pitch used when the ESC SI command isreceived. Select 17.1 cpi [the default] or 20 cpi.FF FunctionApplies to the manual feed from the platform.Sets what happens when the printer receives the FF command.Eject [the default] or Form Feed.Form Tear-OffThe default is Off. To activate Form Tear-Off, change the settingto On.The Forms Tear-Off feature allows a printed continuous formpage to be torn off without wasting paper or adjusting theprinter.For more information, see page 75.Front Load Adj.For fine tuning the Top of Form (TOF) location when usingcontinuous forms (front feed). Settable from -40 to +40 inincrements of 1/144 inch. The default is 0.