Oki Microline 8810 User Manual

Also see for ML8810: Setup guide Installation instructions Brochure Safety & warranty Hardware installation instructions

Contents

Microline 8810 Userís Guide80Change to a Manual Printhead Gap SettingìOn-the-FlyîIf you are switching to a different print media and wish to temporarilychange the printhead gap setting for that media, you can use the controlpanel switches to change the printhead gap setting. The setting will bemaintained until the printer is turned off or until it it receives an I-Primesignal.You can also use this feature to try different settings for your media, then setthe best one(s) as the printer default in the Menu (see below).1. Press the SEL switch to deselect the printer.2. Press and hold the SHIFT switch, then press the LOAD switch repeatedlyto scroll through the various settings for the printhead gap.3. When the desired setting appears on the display, press the SEL switchto place the printer back on line.In the MenuIf you wish to change the printhead gap and continue to use the manualsetting even if the printer is turned off, it must be done in the printer Menu.You can establish two different printhead gap settings in the menu: one inthe Manual Feed group and one in the Form Feed group.Note You can also use the menu to set the printhead gap for the optionalCSF and the optional Rear Push Tractor.1. Press the SEL switch to deselect the printer.2. Press SEL.The printer goes off-line.3. Simultaneously press SHIFT and MODE.PRINTER CONTROL displays.4. Press and hold SHIFT, then press FF repeatedly until MANUAL FEEDdisplays.8810_3_crop.jpg