Microline 8810 Userís Guide58Gap Pos.When Auto Gap detection is enabled, this sets how far in fromthe left edge of the form the gap detection begins: 2 inches (51mm) [the default] or 4 inches (102 mm).GraphicsThe default is Bi-directional. Changing to Uni-directional willimprove the print registration, but slow the print speed.Graphics DataSets graphics data to print 7 Bits [the default] or 8 Bits.High SkipThe default is Yes. This enables the low-vibration mode, whichreduces printer vibration during printing. To switch low-vibrationmode off, change this setting to No.Host InterfaceChoose the interface mode: Auto Interface [the default],Parallel, USB, or Option I/F.I-PrimeThe default is Enable: print out the buffer contents when theI-Prime signal is received. Change to Disable if you wish theprinter to ignore the I-Prime signal.I/F Time OutAppears only if Host Interface is set to Auto Interface [thedefault].Choose the amount of time the printer waits (while receivingdata) before going into idle mode: 15 sec [the default], 30 sec,45 sec, 1 min, 2 min, 3 min, 4 min, or 5 min.If your software spends a long time processing between portionsof data it feeds to the printer, choose a longer time interval valueto keep your printer from dumping the received data while it iswaiting for more.Impact ModeSelects the print mode, Normal [the default] or Quiet, engagedon power up.