Oki Microline 8810 User Manual

Also see for ML8810: Setup guide Installation instructions Brochure Safety & warranty Hardware installation instructions

Contents

Microline 8810 Userís Guide72c. To move the TOF further up on the page (print paper retractsfurther out of the printer):ñ In 1/144-inch (0.18 mm) increments: press and hold the SHIFTswitch, then press LF.ñ In 10/144-inch (1.75 mm) increments: press and hold the SHIFTswitch, then press MODE.5. Store the TOF position in the printerís memory:a. To store the position as the 1Chr. Set Pos setting, press the SELswitch. The setting will be retained, even if you turn the printer off,until you use this procedure to change the setting. This alsoautomatically sets the TOF setting in the Front Feed group to 1Chr.Set Pos.Note If you reset the printer to the factory defaults, the 1Chr. SetPos you have established will be deleted.b. To store the position in the printerís memory only until it is turnedoff or it receives an I-Prime signal, press the LOAD switch.6. Press SEL to return the printer to the on-line state.Use 1Chr Set PosManual Feed (Single Sheets/Forms)1. Make sure the printer is set to the Manual Feed path.2. Press SEL, then press LOAD to remove the paper from the manual feedpath.3. Simultaneously press SHIFT and SEL.The SEL light starts blinking and the display reads1CHR. SET MODEINSERT PAPER.4. Load a sheet/form on the platform.The sheet/form advances to the printerís default TOF (1/4-inch [6.4mm]) and the display reads 1CHR. SET POS.8810_3_crop.jpg