Panasonic AG-UMR20P Operating Instructions Manual

Also see for AG-UMR20E: Basic operating instructions

Contents

Panasonic AG-UMR20P Operating Instructions Manual Manual pdf 109 page image

- 109 -Menu operation method≥ The Camera Text Menu is not displayed when [PRIORITY MODE] is set to [IP(4K)] or [REC/PB(4K)].≥ Perform the menu operations and exit from the menus using the controller which displayed the Top Menu.If a menu operation has been performed or a menu has been exited using another controller, first display the TopMenu and exit from it using one controller, and then display the Top Menu and exit from it using the other controller.≥ The unit uses a different method to operate its menus from the one employed by the convertible cameras and HDintegrated cameras which have already been launched onto the market. For details, refer to the OperatingInstructions of the camera concerned.≥ The response speed of the camera differs slightly depending on the controller used.Camera Text MenuoperationRemote camera controllerAW-RP50 AW-RP120 AK-HRP200Selecting the unit to beoperatedPress one of the [CAMERA STATUS/SELECTION] buttons.1 Press and hold the [SELECT]button for about 2 seconds.≥ The camera number in the cameranumber display area blinks.2 Press the lit [UP]/[DOWN] button.≥ Press the lit [UP]/[DOWN] button toselect the camera number.3 Press the [SELECT] button.≥ Control of the selected camera isenabled.Displaying the Top MenuPress the [CAMERA OSD] button forabout 2 seconds.Press and hold the [CHARA/MENU]button for about 2 seconds.≥ The Camera Text Menu of this unit is displayed in the IP image. ** The Camera Text Menu is not output from the HDMI OUT terminal/SDI OUTterminal of this unit.Selecting the items Turn the [F1] dial. Turn the [SELECT] dial.Displaying the sub-menus Press the [F1] dial. Press the [SELECT] dial.Returning to the previousmenuWith the cursor at the “Return”position, press the [F1] dial.With the cursor at the “Return”position, press the [SELECT] dial.Changing the settings1 Press the [F1] dial to start thesetting blinking.2 Turn the [F1] dial to change thesetting.3 Press the [F1] dial to enter thesetting (and stop the blinking).1 Press the [SELECT] dial to startthe setting blinking.2 Turn the [SELECT] dial tochange the setting.3 Press the [SELECT] dial to enterthe setting (and stop theblinking).Exiting the menuoperationsPress the [CAMERA OSD] button forabout 2 seconds.Press and hold the [CHARA/MENU]button for about 2 seconds.