Panasonic AG-UMR20P Operating Instructions Manual

Also see for AG-UMR20E: Basic operating instructions

Contents

Panasonic AG-UMR20P Operating Instructions Manual Manual pdf 242 page image

- 242 -∫ It is not a malfunction in following cases∫ PowerOthersTroubleshootingThe lens or LCD monitor fogup.≥ This is due to condensation. This is not a malfunction. Please refer to page 14.When the camera head isshaken, it makes “rattling”sound.≥ This is the sound of the lens moving and is not a defect.This sound will no longer be heard when the unit is turned on and switch toRecording Mode.There is abnormal sound inthe camera head.≥ There will be operation sound during boot, switching of operation mode, orzoom operation. This is not malfunction of the camera head.Object seems to be warped.≥ Object seems to be warped slightly when the object moves across the imagevery fast, but this is because the unit is using MOS for the image sensor. Thisis not a malfunction.When the flash is fired duringshooting, only the top orbottom of the screen becomeslighter≥ With a MOS image sensor, the shooting timing differs slightly between the topleft and bottom right of the screen. This means that when the flash is fired, thebottom of the screen will become lighter in the field concerned and the top willbecome lighter in the next field. This is not a malfunction.Problem Check pointsThis unit cannot be turnedon.This unit does not stay onlong enough.Battery runs down quickly.≥ Connect the Camera Head Optional cable correctly. (l 29)≥ Charge the battery again to ensure it is sufficiently charged. (l 24)≥ In cold places, the battery using time becomes shorter.≥ The battery has a limited life. If the operating time is still too short even afterthe battery is fully charged, the battery has worn out and needs to bereplaced.≥ Securely connect the AC adaptor to the AC outlet.≥ Confirm if the AC cable of the AC adaptor is correctly connected.This unit cannot be operatedthough it is turned on.This unit does not operatenormally.≥ Remove the battery or AC adaptor, wait about 1 minute and then reconnectthe battery or AC adaptor. Then about 1 minute later, turn on the unit again.(Conducting the above operation while the SD card is being accessed maydamage the data on the media.)≥ If normal operation is still not restored, detach the power connected, andconsult the dealer who you purchased this unit from.“ERROR OCCURRED.PLEASE TURN UNIT OFF,THEN TURN ON AGAIN.” isdisplayed.≥ The unit has automatically detected an error. Restart the unit by turning offand on.≥ The unit will be turned off in about 1 minute if the unit is not turned off and on.≥ Repair is needed if it is repeatedly displayed even if it is restarted. Detach thepower connected, and consult the dealer who you purchased this unit from.Do not attempt to repair the unit by yourself.The status indicator flashes afew times in red.≥ An error such as an attempt to perform a recording operation while an SDcard is not inserted has occurred. Check the event log. (l 184, 239)