- 65 -Using the TC data of the SDI output deviceThe values of the time code and the users bit to be recorded in the SDI Mode can be selected by setting[SDI REGEN].Select the menu.≥ The following occurs if you select [ON].j Setups for [TC PRESET] and [UB PRESET] will not be able to change.j The built-in time code (free run) and users bit will be recorded if it is not possible to receive the TC data due tomismatched format, no input data, etc.Each of the USER button can register one function from the 29 available functions.≥ The USER buttons consist of the USER button (USER1) on this unit and 12 USER button icons displayed in theLCD monitor (USER2 to 13).Setting the USER button1 Select the menu.≥ It is not possible to register functions to [USER2] to [USER13] in Playback Mode.2 Touch the item to register.≥ For the functions of the USER button that can be registered, refer to page 67.≥ Touch if not registering.≥ Next (Previous) page can be displayed by touching / .3 Touch [EXIT] to complete the setting.≥ The tables below show the default settings.≥ can only be assigned to [USER1].≥ and can be assigned to any buttons from [USER2] to [USER13].≥ Performing [ALL] in [INITIAL SET] restores these default settings. (l 228): [TC/UB SETUP] # [SDI REGEN][ON]: Records the value of S-LTC area of the camera recorder connected to the SDI INterminal.[OFF]: Records the built-in time code and users bit.RecordingUSER button: [USER SW] # [USER1] to [USER13]USER1 button USER4 button USER2 button USER5 button USER3 button USER6 to 13 buttons ヮユワヶヮユワヶ
