For Long and Trouble-Free Operation: Error Messages 215For Long and Trouble-Free OperationThe following lists major warning messages displayed on the LCD monitor. For details on other warning messages, follow theinstructions given in the messages.PlaylistR-OUT POINT IS NOTAVAILABLE ININSERT MODEAn insert edit cannot use a recorder OUT point. Select some point other than the recorder OUT pointin editing.WRITE PROTECTED! The specified card is write protected. Insert write-enabled media.Item Message Description MeasureError informationError Description OperationNo. MessageE-30 TURN POWER OFF Displayed when an error occurs in reading and writing card data.To continue operation, turn the power off and then back on again.STOPE-37 COMM ERROR Displayed when a system controller command was not complied to.To continue operation, turn the power off and then back on again.STOPE-38 SYSTEM ERROR Displayed when the fan motor stops.To continue operation, turn the power off and then back on again.STOPE-55 OPT SYS ERROR Displayed when an AJ-YCX250G AVCHD codec board (optional) malfunctions. Turnthe power off and then back on again.STOPE-56 OPT NOT RESPONSE Displayed when an AJ-YCX250G AVCHD codec board (optional) does not respondto communications. Turn the power off and then back on again.STOPE-57 OPT HALT Displayed when communications from an AJ-YCX250G AVCHD codec board(optional) cannot be updated. Turn the power off and then back on again.STOPE-BA BATTERY Appears when the input DC voltage is below the undercut voltage. STOPAVCHD warning information (when the AJ-YCX250G AVCHD codec board (optional) isinstalled)Message DescriptionCANNOT BE USED DUE TO INCOMPATIBLE DATA. This data conforms to a different standard and cannot be used.CANNOT PLAY. Cannot play.CANNOT SELECT MORE CLIPS. Too many clips selected to delete.CANNOT SET. THE NUMBER OF INDEXES HAS EXCEEDED THEMAXIMUM LIMIT.Cannot make settings since the number of indexes exceeds the limitCARD ERROR. PLEASE REFORMAT. Formatting failed. This card must be reformatted.CHECK CARD. Check the card.CONTROL DATA ERROR HAS BEEN DETECTED. A control data error was detected.NO CARD No card is inserted.NO FILE. The metadata file cannot be found.REPAIR CLIP? Repair clip?THE CLIP IS PROTECTED. PLEASE CANCEL PROTECTION. The clip is protected. Cancel protection.THUMBNAIL DATA ERROR IS DETECTED. A thumbnail data error was detected.UNABLE TO FORMAT. Cannot be formatted.WRITE PROTECT The card is write protected.
