74 Clip Management: Using SD/SDHC Memory CardsUsing SD/SDHC Memory CardsThis unit can use SD and SDHC memory to store setupmenus, recorded metadata and AVCHD recordings*1.*1 Requires AVCHD codec board (optional accessory).◆ NOTE:• Further information on the above functions is provided in thefollowing sections in this manual.- Loading metadata➝Refer to “Attaching Metadata to Clips” (page 70).- Storing and loading setup menus➝Refer to “Setup” (page 166).- AVCHD recording and playback➝Refer to “Using an Optional AVCHD Board” (page 151).• The SD memory card access lamp lights in orange during AVCHDrecording and playback. It lights in green in the following cases.- While loading metadata- While storing and loading the setup menu- While formatting the card from the P2 card thumbnail screen orthe setup menu- While reading the SD memory card property information on the P2card thumbnail screenUse the following procedure to display SD memory cardstatus on dialog for checking.1 Open the thumbnail screen.2 Press the MENU button.3 Use the cursor buttons to choose [PROPERTY] –[DEVICES] – [SD CARD] and press the SET button.The following information may also appear depending oncard status.• This unit cannot record proxies.4 Press the SET button and the MENU button to endprocessing.Use the following procedure to format an SD memory cardinserted in an SD memory card slot.1 Open the thumbnail screen.2 Press the MENU button.3 Use the cursor buttons to select [OPERATION] –[FORMAT] – [SD CARD].Displaying Miscellaneous SDMemory Card InformationSD STANDARD: Indicates that an SD memorycard is formatted according tothe SD/SDHC standard.SUPPORTED: Complies with SD/SDHCNOT SUPPORTED: Does notcomply with SD/SDHCUSED: Used capacity (bytes)BLANK: Free space (bytes)TOTAL: Total capacity (bytes)NUMBER OF CLIPS: The number of clips on an SDmemory card when clips havebeen copied to an SD memorycard using a proxy or a P2camera recorder.PROTECT: Write protectedFormatting SD Memory Cards
