|
Introduction: Control Reference Guide 33Introduction1. SD/SDHC Memory Card Slot / Access LampInsert an SD/SDHC memory card.Insert the card with the label side facing up and theend with the corner cut off facing in. Push in the carduntil it locks into place. To remove the card, first makesure that the lamp is lit in green or the lamp is notblinking in orange, then push it in the direction ofinsertion to release the lock.➝For recording and playback of optional AVCHD,refer to “Using SD/SDHC Memory Cards” (page 74).◆ NOTE:• Do not insert any cards other than SD/SDHC memorycards.• This unit uses only SD/SDHC memory cards that complywith the SD/SDHC specifications. Other memory cardssuch as MultiMediaCard cannot be used. When using aminiSD memory card, be sure to use an adaptor dedicatedfor use with the miniSD memory card to insert the card intothe SD Memory Card Slot.- MultiMediaCard (MMC) is a registered trademark ofInfineon Technologies AG.- The SDHC (SD High Capacity) card is a new standard,established by the SD Card Association in 2006, forlarge-scale memory cards with capacities above 2 GB.• Cards that will be used on this unit should also be formattedon this unit.• This unit supports the following SD and SDHC memorycard capacities.SD: 8 MB to 2 GBSDHC: 4 GB to 32 GB• For the latest information not available in the OperatingInstructions, visit the P2 support desk at the following Websites.For English: http://pro-av.panasonic.net/• For details on recording and playing back optional AVCHD,refer to “Using an Optional AVCHD Board” (page 151).2. eSATA connectorEnables connection of a hard disk drive with an eSATAconnector using the unit as host device.➝Refer to “Using This Unit With a Hard Disk” (page124).3. USB 2.0 HOST connector (Type A)Enables connection of a variety of devices using theunit as a USB host.P2 store and other USB 2.0 compatible hard disks canbe connected.➝Refer to “Using This Unit With a Hard Disk” (page124).4. USB 2.0 DEVICE connector (Type B)Connect personal computers and other devices foruse in the USB device mode.➝Refer to “Using USB or eSATA Connectors” (page122).◆ NOTE:• Use double shielded cable for making connections to USB2.0 connectors.5. LAN connectorConnect to a 1000base-T, 100base-TX or 10base-Tnetwork.➝Refer to “Connecting This Unit to a Network” (page137).◆ NOTE:• Use a shielded cable to connect to the LAN connector.Side PaneleSATA HOST DEVICEUSB2.0LAN1 3 4 52
|
