76z A USB driver must be installed on the PC.z AJ-SPX800P is only applicable to USB 2.0, not to USB1.1.z Only one AJ-SPX800P at a time must be connected tothe PC via USB.z The P2 card must not be removed when it is connectedvia USB.z While a USB connection is established, the P2 card’saccess LED should not be lit except when access isbeing carried out.z While the USB is turned ON, operations such asrecording, playback and thumbnails will not be available.During a USB connection, “DRIVE” is lit in the statusindication area of a display window.ޓAlso, “USB DRIVE” isdisplayed in the system information/warning area in theviewfinder.When the connection is not correctly established, both ofthese indications blink.3 There are two ways to terminate the USB mode, as follows:z Turn the POWER switch of the AJ-SPX800P OFF.z Set the USB to OFF from the menu operations.5-6 Mounting the Camera on a TripodWhen mounting the camera on a tripod, use the tripod adaptersupplied with the camera.1 Mount the tripod adapter on the tripod.Select an appropriate hole in the adapter, taking intoaccount the center of gravity of the camera and tripodadapter combined.Also, make sure that the diameter of the selected holematches the diameter of the pan head screw.2 Mount the camera on the tripod adapter.Slide the camera forward along the grooves until you hear a“click”.Removing the Camera from the Tripod AdapterWhile holding the red lever down, move the black lever in thedirection of the arrow, and slide the camera backward to removeit.If the tripod adapter pin does not return to its original positionafter the camera has been removed, hold the red lever down andmove the black lever in the direction of the arrow again, in orderto return the pin to its original position.Please note that the camera cannot be mounted if the pinremains in the center.MEDIA E F13 24BATT E FOO40-dB30DRIVE * $ # # % )*Pan headTripod AdapterTripod AdapterRed Lever Black LeverᤨࠫDownloaded From VideoCamera-Manual.com Manuals
